-
1. Connectors
S     Molex / Clik-Mate / 1.25mm / 5p -> Connection to PC-100/200 current Sensor and voltage sense wire.
This cable is standard delivery and comes with any Power-Cube.

The "top" cable (24AWG) connects directly to the main battery for voltage reading (max. 28V / 6S)
Please insert the 18K resistor for voltage readings up to 60V or the 39K resistor for up to 90V into the wire. Use the supplied shrinking tube for isolation.

The "middle" cable (Molex / Clik-Mate / 3p) connects to the P-C sensor board (100A or 200A)

REM: If you want to connect one of the HS-xxx-xx sensor boards or Sensor Hub X2, then please order one adapter cable with DF13 / 6p connector



1    Molex / Clik-Mate / 2.0mm / 6p -> Connection to Pixhawk 2.1 / Power 1

This cable is standard delivery and comes with any Power-Cube.


Connect one connector to the Power-Cube "1" output and the other one to Pixhawk 2.1 

Power 1 input.

2    Molex / Clik-Mate / 2.0mm / 6p -> Connection to Pixhawk 2.1 / Power 2 and/or Servo Rail

This cable is standard delivery for Power-Cube 2, 3 and 4.


Connect the connector with 6 cables to the output "2" at the Power-Cube and the one with 4 cables to Pixhawk 2.1 / Power 2 input.

The JR connector can be connected to the servo rail at PX 2.1, to power up opto ESC's or any other equipment.

Please do not use it to power up digital servos, or any other high current consumption equipment.

REM: If for Power-Cube 2 an higher voltage than 5.3V (for example 12.0V) is ordered, then this cable will be replaced with one of the cables from position 3 or 4 with 3x JR connectors.

3    Molex / Clik-Mate / 2.0mm / 6p -> 3x JR connector
This cable is standard delivery for Power-Cube 4. If you order Power-Cube 3 with 5.3V at output 3, then this cable will be delivered.

Connect it to any high power consumption equipment.
For example connect 2x JR to the servo rail to power up digital servos and the 3rd for LED's or anything else. 

4    Molex / Clik-Mate / 2.0mm / 6p -> 3x JR connector

This cable is standard delivery for Power-Cube 3 and 4.


Connect it to any equipment which requires 12.0V

2. Power-Cube 4 / HS-xxx-xx sensor / Pixhawk 2.1

3. Power-Cube 4 / 2x HS-xxx-xx sensors / Pixhawk 2.1

4. Installation